Lifter
Version 2

       Return To Electrogravitics Page    

Below is another fairly standard design, and this easy to construct Electrogravitic model is known to my fellow Lifter Groupies as the Lifter Version 2. It Lifter is slightly larger than the original single cell 20cm Version 1 model, incorporating a pair of two triangular lifting cells, situated one within the other.

The Lifter Version 2 as shown here employs ordinary 2mm strips of balsa wood, and now measuring 300mm on a side, with uprights that support the emitter wire standing 90mm tall. Combining an aluminum foil skirt which has been trimmed to a 35mm wide, with high quality, ultra fine 50 gauge stainless steel emitter wire, this unit weighs in at right around 7 grams total. Overall, this Lifter Version 2 should be regarded as an extremely efficient design, providing a tremendous amount of lift thanks to it's lightweight construction, and geometric simplicity.

Since this particular model has not given me any problems so far, it has become my trusted "Lifter Demonstrator." All that is required is to pack up the Power Supply, Launch Pad and Lifter, load everything into the car, then upon my arrival, assemble the parts as needed. Then it's simply 'Power On!' to show off this amazing Electrogravitic effect. To date, one has yet been disappointed... 

   Return To Electrogravitics Page